- Easy to install, calibrate and use
- Intuitive to use with a separate display for each detector.
- Safe construction with no high voltage and with electrical insulation
- Battery backup keep dose readings during power failures.
- Detectors with a wide range of integral build-up for different energies
- Interface to computer systems for data communication
- 5 or 10 channel versions available
Technical Data:
Supply voltage: 230 or 115 VAC, 50–60 Hz double insulated mains transformer
Battery backup: 2 x Ni-MH rechargeable batteries 2 x 8,4 volt 170 mAh
Power consumption: Apollo 5: < 15 mA Apollo 10: < 20 mA
Dimensions (w x d x h): Apollo 5: 300 x 160 x 50 mm Apollo 10: 300 x 160 x 70 mm
Weight: Apollo 5: 1,5Kg Apollo 10 1.8kg
Display range: 0 - 19,9 Gy
Resolution: 0,1 Gy
Signal cable: 20 meter
Computer interface: Opto isolated USB (RS232 on demand)
Detectors
Dimensions: 25 x 11 x 6,5 mm
Cable length: 1,2 m
Connector: BNC
Nominal sensitivity: 25-30 nC/Gy
Linearity error: < 1% of full scale
Temperature dependence: 0,1 – 0,3 %/degree
Directional dependence: < 1% within ±60° for the recommended beam quality
Sensitivity drift: < 0.3 %/kGy
Detector types: Electrons and
60CO, 4-8MV Photons, 8-16MV Photons and > 16MV Photons
Software
This section contains the latest software for the Apollo Dosimeter system
The software works with both serial port and USB port products.